Miranda Kaleido-X16 Instrukcja Instalacji Pobierz pdf (Strona 20)

Kaleido-X16 Installation

Power Supplies

PSU slot locations

Two PSUs installed in a frame; front cover removed

Removing a Power Supply

To remove a power supply

1 Open the front cover of the frame and locate the power supply (PSU) you would like to

remove (either the left or the right side).

2 Pull on the handle on the right side of the PSU and pull the PSU out of the frame.

Installing a Power Supply

To install a power supply

1 Position the power supply (PSU) in front of an empty power supply slot in front of the

frame, with the connector end towards the frame and the PSU handle on the right side.

2 Slide the PSU into the empty slot, moving it gently until it contacts the sockets at the

rear of the slot.

3 Push firmly but gently on the PSU faceplate until the PSU’s connectors have mated with

the frame's sockets, and the PSU will go in no further.

Powering up the Kaleido-X16

Separate AC power sockets serve the two power supplies. On the rear of the frame, connect

both power sockets of the Kaleido-X16 to an appropriate power source using the supplied

power cords.

As seen from the rear of the frame:

• The left power socket is for PSU B.

• The right power socket is for PSU A.

Slot A Slot BPSU A removed from Slot A

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 44 45

Brak uwag

Miranda Kaleido-X16 Instrukcja Instalacji Strona 20