Miranda RCP-100 Instrukcje Operacyjne Pobierz pdf (Strona 12)

GUIDE TO INSTALLATION AND OPERATION

8 | RCP-10x0

Bus number (1-4) – enter the following data, depending on the mode selected in the pulldown

• Single bus mode – the number of the bus that is to be controlled

• Dual bus mode – enter the number of the first bus to be controlled (possible values 1, 2 or 3)

o the RCP-10x0 will control that bus and the next one

• The default value is 1

3.4.2 Ethernet Interface

Select the IP addressing mode using the pulldown.

The available choices are:

• DHCP

use dynamic network addressing. When selected, it allows a server to dynamically attribute an IP

address and configuration information to the RCP-10x0. Normally the DHCP server provides at least

the following basic information: IP address, subnet mask and default gateway. When "DHCP" is

chosen, the fixed network parameters are not used unless a DHCP server cannot be found. DNS

servers are usually also reported by the DHCP server (2 are reported but only the primary server is

displayed in the web page)

• Fixed

forces the RCP-10x0 to use the attributes entered in the Fixed IP Mode data boxes. The user should

consult the network manager if unfamiliar with the requirements for this data.

o Enter data for the four listed Fixed IP Mode network parameters

The MAC address is a unique identifier for this specific device, and is not user-configurable.

3.4.3 Densité Chassis

Enter the information that identifies the router that the RCP-10x0 will control.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 32 33

Brak uwag

Miranda RCP-100 Instrukcje Operacyjne Strona 12